|
Installation Instructions:
If purchasing this item as a hardware item,
preferred installation is by way of 4 each 1/4" bolts with nylon
speed nuts with washers. Pre-drill 4 holes per caster through the
bottom of the case using the caster mounting plate as a template.
Pass 4 bolts with 1" steel washers through each hole from inside the
case. Use a minimum 1/2" plywood casterboard between the bottom
of the case and the casters. Install caster over 4 bolts.
Place 1/2" steel washer over bolt, install speed nuts and tighten.
You'll probably need assistance holding the head of the bolt from inside
the case while tightening. For further assistance, call Star Case @
800-822-7827.
|
Limitations:The 3-1/2" heavy-duty swivel/locking
casters are ideally suited for rigorous travel and heavier weight loads. When installed,
these casters elevate your case a total of 5-1/2" off ground surface. Remember, these
casters swivel a full 360 degrees and are offset from their ball-bearing race attachment
points to the case. If your case footprint has a depth dimension that is less than
12"-14", your case is going to have a tendency to tip over when rolling if it's
height exceeds the depth dimension by more than 2 times. We will make recommendations for
optimum caster installation. Always try to keep the weight concentration in your case near
the casters for added stability. |
